|
Quick Setup Guide NS-HTMW01
Portable Fan Heater
Congratulations on your purchase of this high-quality
Insignia product. Your NS-HTMW01 represents the state of
the art in portable fan heaters and is designed for reliable
and trouble-free performance.
Back
PACKAGE CONTENTS
• Portable fan heater
• Quick Start Guide
Switch panel
FEATURES
IMPORTANT SAFETY INSTRUCTIONS
• Wire heating element
• Two power settings: 750 and 1200 Watt
• Silent operation
1 Read all instructions before using this heater.
2 This heater is hot when in use. To avoid burns, do not let bare skin
touch hot surfaces. Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from
the front of the heater and keep them away from the sides and rear.
3 Extreme caution is necessary when any heater is used by or near
children and whenever the heater is left operating and unattended.
4 Always unplug heater when not in use.
5 Do not operate any heater with a damaged cord or plug or after
the heater malfunctions, has been dropped or damaged in any
manner. Discard heater, or return to authorized service facility for
examination and/or repair.
Switch
• Red LED power light
• Double over-heating protection
• Removable rear cover for easy cleaning
• Dust filter
Filter
cover
Front
6 Do not use outdoors.
LED indicator
Frame
7 This heater is not intended for use in bathrooms, laundry areas
and similar indoor locations. Never locate heater where it may fall
into a bathtub or other water container.
8 Do not run cord under carpeting. Do not cover cord with throw
rugs, runners, or similar coverings. Do not route cord under
furniture or appliances. Arrange cord away from traffic area and
where it will not be tripped over.
Back
stand
Grill
9 To disconnect heater, turn controls to off, then remove plug from
outlet.
10 Do not insert or allow foreign objects to enter any ventilation or
exhaust opening as this may cause an electric shock or fire, or
damage the heater.
11 To prevent a possible fire, do not block air intakes or exhaust in
any manner. Do not use on soft surfaces, like a bed, where
openings may become blocked.
USING YOUR PORTABLE FAN HEATER
1 Remove the heater from the package and place on a level
surface, such as a floor or desk top.
2 Plug the power cord into a standard 120V outlet. The red
LED turns on.
12 A heater has hot and arcing parts inside. Do not use it in areas
where gasoline, paint, or flammable liquids are used or stored.
13 Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause fire, electric
shock, or injury to persons.
14 Always plug heaters directly into a wall outlet/receptacle. Never use
with an extension cord or re-locatable power tap (outlet/power strip).
15) SAVE THESE INSTRUCTIONS
OFF
LOW
HI
Slide the switch to the middle position.
Slide the switch to the left.
Front stand
Slide the switch to the right.
Before using your new product, please read these
instructions to prevent any damage.
|