ElevatedToilet Seat
Assembly,Installation and Operating Instructions
Model No. 1384
4. Loosen vertical mounting bolt with wrench provided.
SAVE THESE INSTRUCTIONS
5. Position adjustable elevated toilet seat onto toilet
bowl.
NOTE: Check all parts for shipping damage. In case of
shipping damage, DO NOT use. Contact Dealer/Carrier
for further instruction.
6. Twist or pivot each mounting bracket against toilet
bowl rim.
7. After all four (4) mounting brackets have been posi-
SAFETY SUMMARY
Thefollowingrecommendationsaremadeforthesafe
installation of the Elevated Toilet Seat:
tioned properly, securely tighten ALL mounting bolts.
Elevated
Toilet Seat
GENERAL WARNINGS
DO NOT insta ll this e quipme nt without first re a d-
ing a nd understa nding this instruction sheet. If you
a re una ble to unde rsta nd the se Wa rnings, Ca u-
tions a nd Instruc tions, c onta c t a he a lthc a re pro-
fe ssiona l, de a le r or te c hnic a l pe rsonne l if a ppli-
c a ble be fore a tte mpting to insta ll this e quipme nt
- othe rwise , injury or da ma ge ma y oc c ur.
Vertical
Horizontal
Mounting
Mounting
Bolts
Bolts
Mounting
Brackets
Alwa ys c he c k to ma ke sure tha t the Ele va te d
Toilet Sea t is properly a nd securely locked in pla ce
be fore using.
Ensure tha t a ll four (4) mounting bra c ke ts a re a d-
justed to the sa me height-otherwise injury or da m-
a ge ma y oc c ur.
Toilet Bowl
Be sure to c e nte r your we ight on the Ele va te d
Toile t Se a t be c a use the se a t ma y tip if you le a n
too fa r forwa rd or to e ithe r side .
FIGURE 1 - SEAT INSTALLATION/REMOVAL
Use rs with limite d physic a l c a pa bilitie s should be
supe rvise d or a ssiste d whe n using the Ele va te d
Toile t Se a t.
SEAT REMOVAL (FIGURE 1)
NOTE: Refer to the GENERAL WARNINGS in the
SAFETY SUMMARY of this instruction sheet.
The Ele va te d Toile t Se a t ha s a re c omme nde d
we ight limita tion of 250 lbs.(114 kg.).
1. Loosen horizontal mounting bolts on all four (4)
mounting brackets.
2. Lift up Elevated Toilet Seat off of the toilet bowl.
SEAT INSTALLATION (FIGURE 1)
NOTE: Refer to the GENERAL WARNINGS in the
SAFETY SUMMARY of this instruction sheet.
CLEANING PROCEDURES
1. Remove contents from the carton.
WARNING
NOTE: There are three (3) height adjustment positions.
The Elevated Toilet Seat is shipped in the middle position.
DO NOT use a n a bra sive de te rge nt, c le a ne r or
c loth to c le a n/dry the Ele va te d Toile t Se a t.
2. Remove two (2) horizontal mounting bolts and ad-
just bracket to desired height. Finger tighten only.
Repeat for remaining three (3) brackets.
1. Use a non-abrasive detergent or cleaner with warm
water.
2. Rinse with warm water and wipe dry with a non-abra-
sive cloth.
3. Visually inspect that all four (4) mounting brackets
are adjusted to the same height.
OVER
|