CS SERIES
CS2165C
component system
owner’s manual
THANK YOU
for purchasing a JBL CS Series automotive
®
loudspeaker component system. We’ve organized
this manual to make your installation as simple
and trouble-free as possible. Please read it
thoroughly before proceeding. Remember to
keep your sales receipt and this manual in a safe
place so both are available for future reference.
INSTALLATION
Figure 1. Mounting the woofer in a factory
location without the grille.
I-MOUNT™ FLUSH-MOUNT
Figure 3A. Mounting the tweeter using the
I-Mount flush-mounting kit.
TWEETER ANGLE
Figure 4. Aim the tweeter at the listening
position by sliding the screw in the groove
on the back of the tweeter cup and lock the
tweeter in place using the small retaining
screw. Rotate the entire assembly in the
mounting surface and tighten the large
hand nut.
3
1
3
ROTATE ENTIRE ASSEMBLY
TO AIM ANGLED TWEETER
TOWARD LISTENER.
2
1
SLIDE SCREW UP OR
DOWN TO ADJUST
TWEETER ANGLE.
I-MOUNT SURFACE-MOUNT
Figure 3B. Mounting the tweeter using the
I-Mount surface-mounting cup.
Figure 2. Mounting the woofer with
the grille.
2
TIGHTEN SCREW TO
LOCK ANGLE SETTINGS.
BLACK (—)
1
ATTACH BASE
4
SECURELY TIGHTEN
WITH SCREWS, THEN:
RED (+)
THE LARGE HAND NUT.
2
3
Note: Check screw clearance before
installing. Use glue if clearance is an issue.
Note: Not all possible mounting
configurations are shown.
3
CONNECTIONS
SPECIFICATIONS
CS2165C
Connect the tweeter using the supplied
wire with inline crossover to the terminals
on the woofer. Note that there are two
positive and two negative terminals on
the woofer. Connect the unused positive
and negative terminals to your amplifier‘s
output leads, observing proper polarity.
You must use the supplied inline crossover.
Failure to do so may damage the tweeter.
Figure 5. Wiring connections
Type
165mm Two-way
component system
Power Handling
Sensitivity (2.83V/1m)
45W RMS,
135W Peak
91dB
Frequency
Response
55Hz – 20kHz
Impedance
4 Ohms
Mounting Depth
Cutout Diameter
Overall Diameter
2-3/8" (61mm)
5-11/16" (145mm)
6-9/16" (167mm)
GENERAL CARE
The loudspeaker grilles may be cleaned with a damp cloth. Do not use any cleaners
or solvents on the grilles or the speaker cones.
This product is designed for mobile applications and is not intended for
connection to the mains.
A valid serial number is required for warranty coverage.
Features, specifications and appearance are subject to change without notice.
Not all models are available in all markets.
Declaration of Conformity
To Amplifier
JBL, Incorporated
250 Crossways Park Drive, Woodbury, NY 11797 USA
We, Harman Consumer Group International
2, route de Tours
72500 Château du Loir
France
© 2006 Harman International Industries, Incorporated. All rights reserved.
declare in own responsibility that the product described in this owner’s
manual is in compliance with technical standards:
JBL and Harman International are trademarks of Harman International Industries,
Incorporated, registered in the United States and/or other countries. I-Mount and
Starfish are trademarks of Harman International Industries, Incorporated.
EN 61000-6-3:2001
EN 61000-6-1:2001
Klaus Lebherz
Harman Consumer Group International
Château du Loir, France 6/06
Part No. CS2165COM6/06
www.jbl.com
|