™*
JBL ON STAGE 400P
HIGH-PERFORMANCE SPEAKER DOCK
FOR iPhone AND iPod
iPhone not included
USER GUIDE
English............................... 3
FCC STATEMENT AND WARNING
This devvice coompliiees witthh Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may nott cause harmful interference, and
2) this devvice must aaccept anny interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits arree
desiiggnneedd ttoo providee reasonaabble protecction agaiinst harmfful interrference iinn a residenntial insttallatioonn. This eqquuipment geeneratess,, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful intterfeerrence tto raddio coommunications. However,
there is nno guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or telleevviissiioonn
receeppttiioonn,, wwhhiicchh ccaann bbee deetermineed by turnning the eequipmeent off anndd on, the uuser is enncouraggeed to tryy tto correcct the inntterference by one or more of the
following mmeasures:
• Reorient the receiving antenna.
• Increase the seeparaattion bbeetweenn the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Any speciial acceesssories nneeded foor compliannce must be specified in the instruction manual.
MODIFICATTIONSS NOT EEXXPRESSLYAPPROVEDBYTHEMANUFACTURERCOULDVOIDTHEUSER’SAUTHORITYTOOPERATETHEEQUIPMENTUNDERFCCRULES.
CAUTION
WARNING:TO PREVENT FIRE OR
ELECTRICAL SHOCK HAZARD, DO NOT EXPOSE
THIS PRODUCT TO RAIN OR MOISTURE.
IMPORTANT:
RISK OF ELECTRIC
SHOCK
—
DO NOT OPEN
THE APPROPRIATE ADAPTER MUST BE INSTALLED BEFORE
INSERTING YOUR iPod/iPhone INTO THE JBL® PRODUCT.
MAKE SURE THAT THE CONNECTOR FOR THE iPod/iPhone IS
PROPERLY ALIGNED WITH THE JBL PRODUCT’S CONNECTOR
WHEN INSTALLING YOUR iPod/iPhone. FAILURE TO DO SO
MAY CAUSE PERMANENT DAMAGE TO THE CONNECTOR FOR
THE iPod/iPhone, RENDERING THE iPod/iPhone INOPERABLE.
THE LIGHTNING
FLASH AND
ARROWHEAD
WITHIN THE
TRIANGLE IS A
WARNING SIGN
ALERTING YOU
TO DANGEROUS
VOLTAGE INSIDE
THE PRODUCT.
THE EXCLAMATION
POINT WITHIN
CAUTION: TO REDUCE
THE RISK OF SHOCK, DO
NOT REMOVE COVER. NO
USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING
TO QUALIFIED SERVICE
PERSONNEL.
THE TRIANGLE IS
A WARNING SIGN
ALERTING YOU
TO IMPORTANT
INSTRUCTIONS
ACCOMPANYING
THE PRODUCT.
WARNING:THE APPARATUS SHOULD
NOT BE EXPOSED TO DRIPPING OR SPLASHING
AND NO OBJECTS FILLED WITH LIQUID, SUCH AS
VASES, SHOULD BE PLACED ON THE APPARATUS.
WWW.JBL.COM
5
™*
JBL ON STAGE 400P
HIGH-PERFORMANCE SPEAKER DOCK FOR iPhone AND iPod
®
The JBL On Stage™* 400P high-performance speaker dock is the latest JBL innovation. As a longtime leading brand in high-end,
professional component audio systems, JBL represents a unique audio heritage, incorporating continual research, to provide the
superior technologies built into the JBL On Stage 400P system.
This complete docking sound system for iPod/iPhone is the new centerpoint of your personal entertainment space. Imagine a combined
subwoofer and satellite sound system in one place, with no extra wires running across your table or desk surface. The compact
JBL On Stage 400P high-performance sound center is controllable by remote, up to 15 ft. away. Connected to your iPod/iPhone, MP3
player or any other music source with an audio jack, the system produces clean, powerful sound. Take complete control of your music
and videos with the JBL On Stage 400P speaker dock.
COMPATIBILITY
The JBL On Stage 400P system is compatible with all docking versions of the iPod/iPhone. A stereo mini jack connection also
allows you to enjoy high-quality audio from a variety of other devices, such as iPod shuffle, MP3 and CD players, desktop computers
(all platforms), satellite radio and laptops.
REMOTE
Just a touch of the Volume controls increases or decreases the volume. Using the Navigation controls, browse songs and photos,
change tracks and settings, and more. With the JBL On Stage 400P remote, you have complete control of your iPod/iPhone, as though
it were in your hand.
EVERCHARGE TOPOLOGY
The unit charges your iPod/iPhone, even when not connected to the computer or when the system is off.
COMPACT DESIGN
The JBL On Stage 400P loudspeaker dock is a complete 2.1-channel audio system, in one easy-to-place footprint.
DIGITAL POWER AND DSP
The system delivers sound with a powerfully tuned digital audio path. The clean and compact digital amplification, coupled with DSP
(digital signal processing) equalization, efficiently provides the transducers with cool-running power.
JBL ON STAGE 400P USER GUIDE
6
™*
UNPACKING YOUR JBL ON STAGE 400P
Carefully unpack your speaker system and identify all its components:
JBL
MENU
JBL On Stage™* 400P
Adapters for
iPhone and iPod
IR remote
Power supply
Audio cable
QUICK SETUP INSTRUCTIONS
Plug the barrel end of the power supply cord into the power jack and plug the other end into the wall.
Next,, pushh tthe powwer swwitch; a greeen LEEDD will llightt up, inndicaatting tthhat the unitt is poowwered.
Find the coorrect adapter for your iPod/iPhone, then firmly place it iinto the ddoocking areea shown.
Next, pplace yyoour iPodd/iPhone into the dock, making sure your iPod/iPhone is firmly seated.
Adjusst the voolume,, usingg ((+) to inncreasse and ((–) too ddecreaase. Prress booth to muute thee JBL Onn Stagee 400P unit.
Press eiither bbuttoonn to unmute.
•
•
•
•
•
Power
Jack
Auxiliary
Port
Power
Switch
Power
DC-In
JBL
Audio-In
DC-In
Power
Audio-In
WWW.JBL.COM
7
SPECIFICATIONS TROUBLESHOOTING
JBL ON STAGE™* 400P
SOUND QUALITY
Frequency Response: 40Hz – 20kHz
Symptom
Possible Problem Solution
Note
Power Consumption: 55 Watts maximum
No sound from the
JBL On Stage 400P unit.
No power to the unit.
Make sure the wall power outlet or power
strip has power. Make sure all switches for
the outlet/power strip are on and that all
switches for the speaker system are on.
Is the LED on? If not,
power is not getting
to your JBL On Stage
400P system; try the
solutions shown.
JBL On Stage 400P Transducers: One Atlas™ (45mm)
neodymium and four Odyssey® (25mm)
Power: 1 x 30 Watts (woofer)
Incorrect source selection.
Make sure the iPod/iPhone is properly
docked or that the auxilary cable is prop-
erly connected to an external audio device.
Turn up the volume. Check the system with
a known good source, such as your iPod/
iPhone. Connect the Auxiliary Port cable to
the headphone jack on your iPod/iPhone.
2 x 15 Watts (tweeters), at 1% THD
Input Impedance: >10k Ohms
Signal-to-Noise Ratio: >85dB
Input Sensitivity: 250mV RMS for rated power output
Power (USA/Canada): 120 Volts, 60Hz AC
Power (Europe/UK): 220 – 240 Volts, 50Hz or 60Hz AC
Power (Japan): 100 Volts, 50Hz or 60Hz AC
Power (Australia): 240 Volts, 50Hz or 60Hz AC
UL/CUL/CE-Approved
Sound comes from one
side/channel only.
iPod/iPhone or audio cable is
not seated properly.
Make sure the iPod/iPhone or Auxiliary
Port cable is seated all the way into the
JBL On Stage 400P unit.
If you are using a longer
cable, make sure it’s a
3.5mm mini-jack stereo
male-to-male cable.
Distortion (static,
crackling or
hissing sounds).
Noise may be caused
by interference from a
monitor, cell phone or
other transmitting device.
Turn monitor off to see whether noise is
eliminated. Move JBL On Stage 400P unit’s
cables farther away from monitor.
Too much bass
or treble.
JBL On Stage 400P is being
overdriven by an amplified
audio source.
Make sure that the JBL On Stage 400P
unit is connected to an appropriate source
device.
Dimensions: 14-1/4" x 7-3/16" x 3-3/4"
(W x D x H) (362mm x 183mm x 95mm)
Make sure all signal cables are inserted
snugly into receptacles.
Weight: 3.8 lb (1.7kg)
Volume level may be too high.
Check volume of source device.
Power Supply Manufacturer: JBL, Inc.
Power Supply Model: 700-0084
Some devices will distort the output signal
if the volume is set to Maximum.
Check the EQ setting on your
iPod/iPhone or source device.
It is recommended that the source device
EQ be set to Flat or Off.
JBL On Stage 400P unit
emits a loud hum or buzz-
ing noise.
Input cables are not plugged
in properly.
Check input cable connection.
Speaker system experi-
ences radio frequency
interference or picks up a
radio station.
Input cable may be picking up
interference.
Wrap up excess input cable, in order
to make it as short as possible.
Error message: “Device is
not iPhone Compatible” is
displayed on iPhone after
docking on the unit.
iPhone has an old firmware
version.
Upgrade iPhone firmware to latest version.
Undock & re-dock iPhone in unit.
JBL ON STAGE 400P USER GUIDE
8
TROUBLESHOOTING
CHARGING
Symptom
Possible Problem
Solution
Note
iPod/iPhone will not charge.
Wrong adapter is used.
Make sure correct adapter is used for your specific
iPod/iPhone model.
The iPod/iPhone is not making full contact
with the docking station.
Make sure the iPod/iPhone is seated securely into the
docking station.
DISPOSAL: Do not dispose of this product as unsorted municipal waste. Collection of such waste separately for special treatment is necessary.
IMPORTANT: Use UM4/AAA/LR03 alkaline-type nonrechargeable batteries only.
WWW.JBL.COM
9
JBL and Odyssey are trademarks of Harman International Industries, Incorporated, registered in the United States and/or other countries. Atlas is a trademark of Harman
International Industries, Incorporated.
The trademark On Stage is used with permission of OSA International, Inc.
*
iPod is a trademark of Apple Inc., registered in the U.S. and other countries. iPhone and Shuffle are trademarks of Apple Inc. iPod and iPhone not included. “Made for iPod” means
that an electronic accessory has been designed to connect specifically to iPod and has been certified by the developer to meet Apple performance standards. “Works with iPhone”
means that an electronic accessory has been designed to connect specifically to iPhone and has been certified by the developer to meet Apple performance standards. Apple is not
responsible for the operation of this device or its compliance with safety and regulatory standards.
Harman Consumer Group, Inc.
8500 Balboa Boulevard, Northridge, CA 91329 USA
516.255.4525 (USA only)
© 2008 Harman International Industries, Incorporated. All rights reserved.
Part Number: 950-0253-001 Rev. C
|