ENGLISH
ESPAÑOL
FRANÇAIS
PORTUGUÊS
中文
HD MEMORY CAMERA
U
GC-FM1
Basic User Guide
For more details on the operations, refer
to the “Detailed User Guide”in the internal
memory. (p. 4)
1SM321404
FCC WARNING
(For owners in the U.S.A.)
Changes or modifications not approved by JVC could
void the user’s authority to operate the equipment.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures: Reorient or relocate
the receiving antenna. Increase the separation between
the equipment and receiver. Connect the equipment
into an outlet on a circuit different from that to which
the receiver is connected. Consult the dealer or an
experienced radio/TV technician for help.
(For owners in the U.S.A.)
This equipment may generate or use
radio frequency energy. Changes or
modifications to this equipment may
cause harmful interference unless the
modifications are expressly approved
in the instruction manual. The user
could lose the authority to operate this
equipment if an unauthorized change
or modification is made.
(For owners in the U.S.A.)
•
The supplied interface cable must be
used with the equipment in order to
comply with the limits for a digital
device pursuant to Subpart B of Part 15
of FCC Rules.
•
Use an HDMI cable with the HDMI logo.
3
Accessories
Viewing the “Detailed
• USB Cable
Preparation:
(WUU102SCP001)
•Charge the camcorder. (p. 8)
•Turn on the computer.
•Press the < button for more than
• AV Cable
•C1osnecnoencdt tthoetcuarnmoconrtdheerctoamacorder.
computer.
(WPU122SCP001)
• Hand Strap
To Computer
• Application software
The supplied software is pre-
installed in the camcorder.
Refer to the “Detailed User Guide”
on the right column for installing
software.
<Button
USB Cable
USB Connector
4
User Guide” in the internal memory
Ⅵ For Windows user
! The “FMCAM_FRM”window appears.
# Select [MediaBrowser LE Install and User Guide].
$ Select [Detailed User Guide].
% Click a language.
Ⅵ For Mac user
! Double-click [FMCAM_FRM] on the desktop.
# Double-click [FM1_guide].
$ Double-click [FM1_start.pdf].
% Click a language.
5
Names of Components
Focus Switching Lever
Normal Recording [M]
LCD Monitor
Charge Lamp
Status (Warning) Lamp
Macro Recording [
]
Power Button [<]
Recording Select Button
Power Lamp
!
Video [
Still Image [
]
#
]
%
Select Button [
Recording/Playback
]
7
]
Index Button [
Reset Hole
$
Delete Button [
]
• If the camcorder malfunctions,
push into the reset hole with a
pointed object such as a wire to
initialize the camcorder.
Hand Strap
Attachment Area
¡ ¢ £ ¤
Recording Start/Stop Button
Shutter Button
Set Button
,
,
,
Buttons
Zoom Buttons
Volume Buttons
6
Inserting an SD Card
Lens
Operations are confirmed on the
following SDHC cards (class 4 or higher)
with capacity 4 GB to 32 GB. Panasonic,
TOSHIBA, SanDisk, ATP.
Microphone
AV Connector
HDMI Connector
USB Connector
SD Slot Cover
Speaker
Tripod Mounting
Socket
To conserve power, the camcorder turns off
automatically if there is no operation for 3 minutes.
7
Charging
Charge the battery connecting to PC with the USB cable.
1
Press the < button to turn off
the camcorder.
The power lamp goes out.
To Computer
Charge Lamp
2
Connect the camcorder to a
computer.
< Button
Power Lamp
turns on: Charging
goes out: Charging finished
Charge lamp
USB Cable
Charging time approx. 180 minutes
USB Connector
NOTE
•Charging is not possible while the camcorder is turned on.
•Make sure that the computer is turned on during charging.
8
Setting Date and Time
Preparation:
Turn on the power and select the recording mode.
1
2
3
4
5
$
While pressing the button,
press the button.
7
Select [Time setup], and then
press the set button.
Set the date and time by selecting items with
¡ ¢
,
£ ¤
and setting values with
,
.
After completing the setting,
press the set button.
Select [Exit] to quit the screen.
NOTE
•When you first turn on the power after purchasing the camcorder, the [Time
setup] screen appears.
9
Video Recording/Playback
Preparation:
During recording, the screen
display changes to red
! #
!
Press the
/
button to select
mode.
Ⅵ1Video Recording
Press the set button to start recording.
Press it again to stop the recording.
Ⅵ1Video Playback
%
!
: Video mode
Press the button to select the playback
mode.
2
3
¡ ¢ £ ¤
Press the
,
,
,
buttons to select a video.
Press the set button to start playback.
Press it again to stop the playback. To return to the
7
index screen, press the
button.
10
Still Image Recording/Playback
Preparation:
! #
#
Press the
/
button to select
mode.
Ⅵ1Still Image Recording
Press the set button to take a still image.
#
: Still image mode
Ⅵ1Still Image Playback
%
Press the button to select the playback mode.
2
3
¡ ¢ £ ¤
Press the
,
,
,
buttons to select a still image.
Press the set button.
Ⅵ To delete a video or still Image
! While a video or still image is selected, playing back or displayed, press the
$
button.
£ ¤
# Press the
,
buttons to select [Yes], and then press the set button.
11
Viewing Files on TV
Saving Files on a Computer
1
Connect the camcorder to a TV. Preparation:
•Charge the camcorder before saving.
2
3
Select the external input mode
on the TV.
•Turn on the camcorder.
1
Connect the camcorder to a
computer.
Play back the video or still
image. (p. 10, 11)
Windows Double-click [FMCAM_SD]/
[FMCAM_INT] in [My
To TV
Computer].
Macintosh Double-click [NO_NAME]
AV Cable
on the desktop.
AV Connector
2
Copy the video or still image
files from the “DCIM” folder.
NOTE
•Also refer to instruction manual of the
TV.
12
|