ENGLISH
FRANÇAIS
Warnings, Cautions and Others
For Canada
THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS AS SET OUT IN THE
INTERFERENCE-CAUSING EQUIPMENT STANDARD ENTITLED “DIGITAL APPARATUS,” ICES-003 OF THE DEPARTMENT OF COMMUNICATIONS.
WARNING
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS
APPARATUS TO RAIN OR MOISTURE.
SPEAKER SYSTEM
For U.S.A.
Caution: Changes or modifications not expressly approved by party responsible for compliance could void the user’s authority to operate the
equipment.
XS-SR1
INSTRUCTIONS
CAUTION
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
The button in any position does not disconnect the mains line.
Disconnect the mains plug to shut the power off completely (the
STANDBY lamp goes off).
The MAINS plug or an appliance coupler is used as the disconnect
device, the disconnect device shall remain readily operable.
• When the System is on standby, the STANDBY lamp lights red.
• When the System is turned on, the STANDBY lamp turns green.
Thank you for purchasing a JVC product.
For customer use:
Enter below the Model No. and Serial No. which
are located either on the rear, bottom or side of the
cabinet. Retain this information for future reference.
Model No.
Serial No.
0809WMKMDWJMM
EN, FR
GVT0298-001B[J]
Declaration of Conformity
Model Number:
Trade Name:
Responsible Party:
Address:
XS-SR1
JVC
© 2009 Victor Company of Japan, Limited
JVC Americas Corp.
1700 Valley Road, Wayne New Jersey 07470
973-317-5000
CAUTION
• Do not block the ventilation openings or holes. (If the ventilation openings or holes are blocked by a newspaper or cloth, etc., the heat may
not be able to get out.)
• Do not place any naked flame sources, such as lighted candles, on the apparatus.
• When discarding batteries, environmental problems must be considered and local rules or laws governing the disposal of these batteries must
Telephone Number:
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
be followed strictly.
• Do not expose this apparatus to rain, moisture, dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on
the apparatus.
[European Union only]
CAUTION
To reduce the risk of electrical shocks, fire, etc.:
1. Do not remove screws, covers or cabinet.
2. Do not expose this appliance to rain or moisture.
Rating label is placed on the exterior of the bottom.
Precautions
Connection
Specifications
• Install the System on a place which is level, dry, and neither too hot
nor too cold; between 5°C and 35°C (41°F and 95°F).
• Do not use the System in a location near heat sources, or in a place
subject to direct sunlight, excessive dust, or vibration.
• Leave sufficient distance between the System and the TV.
• Do not insert any metallic objects or liquids into the System.
• There are no user-serviceable parts inside. If anything goes wrong,
disconnect the USB cable (or AC adaptor) and consult your dealer.
• Stains on the System should be wiped off with a soft cloth. If the
System is heavily stained, wipe it with a cloth soaked in water diluted
neutral detergent and wrung well, then wipe clean with a dry cloth.
• If water gets inside the System, turn the power off and disconnect
the USB cable (or AC adaptor), then call the store where you
purchased this System. Using the System in this condition may cause
a fire or electrical shock.
For supplying the power:
CAUTION
Output power:
• Connect the System to a computer using the USB cable (supplied), or DO NOT turn on the computer until all connections have been made.
• Connect an AC adaptor (not supplied).
• USB connection
0.75 W per channel, RMS at 4 Ω at 1 kHz, with 10% total
harmonic distortion
• AC adaptor connection
2.5 W per channel, RMS at 4 Ω at 1 kHz, with 10% total
harmonic distortion
Speaker Type:Full-Range Bass-Reflex Type (Magnetically-Shielded Type)
Speaker:
Speaker Impedance:
Analog Input (ANALOG IN):
Digital Input (DIGITAL IN):
USB Input (USB IN):
Power Source:
NOTE
• Do not use a USB hub to connect the System to a computer.
• If you connect both the USB cable and an AC adaptor, connect the AC
adaptor first. Otherwise the System may not work correctly.
4 cm (1-5/8”) cone × 2
4 Ω
125 mV/50 kΩ
–21 dBm to –15 dBm (660 nm 30 nm)
DC 5 V 500 mA
Digital optical cable
(not supplied)
Stereo mini plug cable
(not supplied)
Digital output of an audio
player for playing 2-channel
digital audio sources*
Analog output of
an audio player
USB DC 5 V 500 mA
DC 6 V 1 A (DC IN)
• Since the System may deteriorate in quality, become damaged or get
its paint peeled off, be careful about the following:
–DO NOT wipe it forcefully.
–DO NOT wipe it with thinners, benzines or other organic solvents
including disinfectants.
–DO NOT apply any volatile substances such as insecticides to it.
–DO NOT allow any rubber or plastic to remain in contact with it for
a long time.
Dimensions (W × H × D):
390 mm × 88 mm × 136 mm
(15-3/8”× 3-1/2”× 5-3/8”)
0.5 kg (1.2 lbs)
* Compatible signal:
2-channel linear PCM
(32 kHz, 44.1 kHz,
and 48 kHz sampling
frequency). No
multi-channel signal
is playable.
USB cable (supplied)
Mass:
Accessories
USB cable (× 1)
Core filter (small × 2/large × 2*)
* Refer to “How to attach the core filter to the USB cable” on the
attached information sheet.
or
AC adaptor (not supplied)
Connect the AC adaptor to the wall outlet.
USB port of a computer
• For supplying the power
• For playing 2-channel digital audio sources
About the built-in speakers
The speakers are magnetically shielded to avoid color distortions on
TVs. If the color on a TV is distorted, perform the following procedure:
–Turn off the TV’s main power switch or unplug it before installing
the System. Then wait at least 30 minutes before turning on the TV’s
main power switch again.
Some TVs may still be affected even though you have followed the
above procedure. If this happens, move the System away from the TV.
When using an AC adaptor or a stereo mini plug cable
When you use an AC adaptor or a stereo mini plug cable (not supplied), make
sure that a core filter is attached to the DC cord end/the stereo mini plug cable
end to reduce interference.
If not, attach one of the supplied core filters (small) as shown in the
illustration.
Run the cable through the core filter, and wind the cable firmly, twice
for DC cord end, once for stereo mini plug cable end, inside the cutout of
the core filter.
Operation
1 Turn on the computer.
Enjoying Surround Mode
For details, refer to the Instruction manual of the computer.
This System is equipped with Virtual Dolby Surround. In Surround
Mode, it creates a rich surround sound effect with two speakers.
To activate Surround Mode, press SURROUND MODE 1/2.
Pressing the button beeps...
2 Press
to turn on the power.
The standby lamp turns green.
3 Press INPUT DIGITAL, INPUT ANALOG or
INPUT USB AUDIO to select the source.
4 Start playing back the connected
equipment.
–Once when SURROUND MODE 1 is selected, or
–Twice when SURROUND MODE 2 is selected.
• SURROUND MODE 1: Creates a surround sound effect.
• SURROUND MODE 2: Creates a richer surround sound effect
than SURROUND MODE 1.
Troubleshooting
Core filter (small)
If you have a problem with this System, check this list for a possible
solution before calling for service.
DC cord
5 Press VOLUME +/– to adjust the volume.
Power does not come on.
–To cancel, press SURROUND OFF.
=Connect the USB cable (or AC adaptor) securely.
=Turn on the computer connected to the System.
No sound comes out of the speakers.
=Adjust the volume level.
CAUTION
5 cm (2 inches)
Set the volume to the minimum level before starting playback. If the
Turning off the operation sounds
volume is set to a high level, the sudden blast of sound may damage your Press and hold SURROUND OFF until the standby lamp flashes twice.
hearing and blow out the speakers.
Core filter (small)
The operation sounds are turned off.
• To restore the sounds, press and hold the button until the standby
lamp flashes once.
Stereo mini
plug cable
Manufactured under license from Dolby Laboratories. Dolby, Pro Logic,
and the double-D symbol are trademarks of Dolby Laboratories.
5 cm (2 inches)
Standby lamp
2
CAUTION
Do not damage the cord by applying excessive force when winding.
5
3
SURROUND MODE buttons
|