CONNECTING YOUR MOUSE
1. Turn off the power to your computer. (You must
Shut Down and Turn Off your computer before
connecting or disconnecting any PS/2 device.
Failure to do so could damage your computer.)
2. Disconnect the existing mouse.
3. Connect your new GE Optical Mouse to the
round mouse PS2 port on your computer.
(Usually this port is green.)
4. Turn on your computer and start your Operating
System.
5. Move the mouse to ensure there is a good
connection.
If your mouse does not work properly, please
check that all connections are secure and the
cable is free of twists. After following these steps,
please contact Jasco product support at
3
FIVE YEAR LIMITED WARRANTY
Jasco Products Company warrants this product to be free from
manufacturing defects for a period of five years from the original date
of consumer purchase. This warranty is limited to the repair or
replacement of this product only and does not extend to
consequential or incidental damage to other products that may be
used with this unit. This warranty is in lieu of all other warranties
express or implied. Some states do not allow limitations on how long
an implied warranty lasts or permit the exclusion or limitation of
incidental or consequential damages, so the above limitations may
not apply to you. This warranty gives you specific rights, and you
may also have other rights which vary from state to state. If unit
should prove defective within the warranty period, return prepaid with
dated proof of purchase to:
Jasco Products Company
10 E. Memorial Road
Oklahoma City, OK 73114
4
FCC STATEMENT
Notice: Federal Communications Commission (FCC)
requirements, Part 15
This equipment has been tested and found to comply with the limits
for a class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for
help.
CAUTION: Any changes of modifications not expressly approved by
the grantee of this device could void the users authority to operate
the equipment. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
is a trademark of the General Electric Company and
is used under license to Jasco Products Company LLC,
10 E. Memorial Road, Oklahoma City, OK 73114.
5
|