GE Wireless Laser Mouse
Instruction Manual
98536
For technical support contact Jasco Products at
Hardware Installation
Please keep these directions in a safe place.
1) Insert the enclosed batteries into the battery compartment
located on the bottom of your mouse. Make sure they are
facing the proper direction.
2) Plug the GE Wireless Laser Mouse receiver into an available
USB port on your computer or GE USB hub. It is not
necessary to reboot your computer.
3) Place your Wireless Optical Mouse within 30 feet
(approximately
communication.
9
meters) of the receiver for optimal
4) Move the mouse to ensure there is a good connection.
5) If the mouse does not work, you may need to move the
receiver closer. See the Troubleshooting section for
instructions.
Page 3
Trouble Shooting
•
The GE Wireless Laser Mouse does not work properly
If your mouse has been idle for a period of time it may be
asleep to conserve battery power. To wake the mouse,
move the mouse.
Ø
Ø
Ø
Change the batteries on your mouse.
Not all laptops support USB mice. Test the mouse on a
desktop computer. If the mouse works, contact your laptop
dealer.
•
Other application software will not install properly
This may be due to the GE Laser Mouse Software. Remove
the software as described in the previous section. Install the
other application. Reinstall the GE Laser Mouse Software.
If these steps do not solve your problem, please contact Jasco
Product’s technical support at 1-800-654-8483 or
Two Year Limited Warranty
Jasco Products Company warrants this product to be free from
manufacturing defects for a period of two years from the original
Page 4
date of consumer purchase. This warranty is limited to the repair
or replacement of this product only and does not extend to
consequential or incidental damage to other products that may be
used with this unit. This warranty is in lieu of all other warranties
express or implied. Some states do not allow limitations on how
long an implied warranty lasts or permit the exclusion or limitation
of incidental or consequential damages, so the above limitations
may not apply to you. This warranty gives you specific rights, and
you may also have other rights which vary from state to state. If
unit should prove defective within the warranty period, return
prepaid with dated proof of purchase to:
Jasco Products Company
10 East Memorial Road
Oklahoma City, OK 73114
Page 5
FCC Statement
Notice: Federal Communications Commission (FCC)
requirements, Part 15
This equipment has been tested and found to comply with the
limits for a class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
•
•
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
•
Page 6
CAUTION: Any changes of modifications not expressly approved
by the grantee of this device could void the users authority to
operate the equipment. This device complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Distributed for GE
by Jasco Products Company
10 East Memorial Road, Oklahoma City, OK 73114
Page 7
|