ANHD20RTL12 INSTALLATION guIde
www.JensenRVDirect.com
Crank existing antenna to full elevation.
1
2
Remove 3/32” set screw from crank. Remove crank,
spring, directional handle, & 4 screws.
TooLs & suppLies
1
Drill or Battery Driver with a #2 Philips bit
2
Putty Knife
3
3/32” Allen wrench
4
Electrical Tape
5
Exterior Roof Sealant (Non-hardening type)
Remove sealant & screws from base,
remove antenna and clean surface
Apply sealant to all holes & attach exterior plate
using the included hardware
4
3
|