1500W Ceramic Cube
Heater
KCE60
Issue 1/08
power outlet when not in use.
IMPORTANT PRECAUTIONS
8. Do not operate heater whilst asleep.
REMOVE AND SAFELY DISCARD
ANY PACKAGING MATERIAL AND
PROMOTIONAL STICKERS BEFORE
USINGTHE HEATER FORTHE FIRST
TIME.
9. Do not operate any heater with a damaged
cord or plug, or if heater has been dropped
or damaged in any manner. Return heater to
your nearest service centre for examination,
electrical or mechanical adjustment or repair.
10. Do not use outdoors. This heater is not
intended for commercial use, such as
construction sites.
TO ELIMINATE A CHOKING HAZARD
FORYOUNG CHILDREN, REMOVE AND
SAFELY DISCARDTHE PROTECTIVE
COVER FITTEDTOTHE POWER PLUG
OFTHIS HEATER.
11. Do not locate the heater immediately below
a socket outlet when in use.
12. Do not use this heater with a programmer,
timer or any other device that switches the
heater on automatically. Since a fire risk may
exist if the heater is covered or positioned
incorrectly.
WHEN USING ELECTRICAL
APPLIANCES, BASIC PRECAUTIONS
SHOULD ALWAYS BE FOLLOWEDTO
REDUCETHE RISK OF FIRE, ELECTRIC
SHOCK AND INJURYTO PERSONS,
INCLUDINGTHE FOLLOWING:
13. This heater is not intended for use in wet
or moist locations. Do not use this heater
in the immediate surroundings of a bath,
a shower or a swimming pool. Do not
immerse or allow liquids to be spilt on
heater.
READAND KEEPTHESE INSTRUCTIONS
FOR FUTURE REFERENCE BEFORE
USINGTHIS HEATER.
14. This heater has hot and arcing or sparking
parts inside. Do not use in areas where
petrol, paints, aerosols, or other inflammable
substances are used or stored.
WARNING: in order to avoid overheating
do not cover the heater.
15. Do not operate the heater with the power
cord damaged, frayed or split, wound around
any part of the heater, or in contact with
heated surfaces of the heater. Do not allow
materials that have been in contact with oil,
petroleum based products or drying fluids to
come in contact with the heater
1. Avoid touching heater body while it is on,
some parts of the heater are hot. When
moving the unit switch off and hold the heater
by the handles where provided.
2. Keep combustible materials such as drapes and
other furnishings at least 1.7 metres from the
front, sides and rear of the heater. Do not use
heater to dry your laundry.
16. Do not run the cord under carpeting or
cover the cord with rugs, runners or the
like. Arrange cord away from traffic areas
and where it will not be tripped over.
3. Extreme caution and supervision is necessary
when this heater is used by or near children,
invalids or animals.
17. To disconnect heater push the heat control
all the way down to OFF, then switch off at
the power outlet then remove plug from its
outlet.
4. This heater is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
18. Do not insert or allow foreign objects to
pass through the inlet or outlet openings.
This may cause an electric shock, fire or
damage the heater.
19. To prevent a possible fire or heat damage,
allow ample space around the heater (at
1.7m at front and 0.5m at the rear, top
and sides) and do not totally or partially
block the air inlet or outlets in any manner.
Check the openings from time to time for
accumulated dust. Ensure long shag carpet
does not obstruct airflow under the unit.
5. Children should be supervised to ensure that
they do not play with the heater.
6. Important – this heater is intended for floor
use only. Do not mount on ceiling or walls.
7. Do not leave heater unattended. Always
switch off the heater at the controls and at
the power outlet then unplug heater from the
ꢁ
20. Switch off at the control switch and power
outlet, then unplug and allow heater to cool
down before cleaning or storing. Use this
heater only as described in this instruction
manual. Any other use not recommended
by the manufacture may cause fire electric
shock or injury and voids all warranties.
5. To decrease the heat settings push down on
the heat control. There will be an audible
click as the wedge moves through the
settings.
6. To turn the heater OFF push the heat
control (used to select “LOW” HEAT or
“HIGH” HEAT settings) all the way down
and the heater will turn off. The power
indicator light will go out.
21. Regularly inspect the supply cord, plug,
control settings, air inlets and outlets and
main housing for any damage. If found
damaged in any way, immediately cease use
of the heater and return to Kambrook or an
authorised service agent for inspection or
repair.
Thermostat control
Turn the heat control to the HIGH setting by
pulling the knob up. Pull up the thermostat
control to the highest thermostat setting.
22. The installation of a residual current device
(safety switch) is recommended to provide
additional safety protection when using
electrical appliances. It is advisable that a
safety switch with a rated residual operating
current not exceeding 30mA be installed in
the electrical circuit. See your electrician for
professional advice.
Let the heater run until the desired room
temperature is achieved.Then push the knob
down until you hear a click sound.The unit will
stop.At this setting, your heater will automatically
cycle on and off to maintain the desired room
temperature.
HOW TO OPERATE:
Once the thermostat is activaed, you can simply
pull the knob up or down if you want to change
the temperature.
1. Remove your heater from its carton and
associated protective wrapping, and unwind
the cord to its full length and remove any
protective cardboard or foam that may
have been used to minimize transportation
damage. Place the heater on a firm, level
surface in a stable upright position. Visually
inspect the air inlet and outlets to ensure no
foreign material is blocking these areas. The
heater must always be operated with the
rear air filter in position.
Thermo Guard Overheating Safety Device
Your heater is fitted with a safety device
that switches off the heater in the event of
overheating. Should this heater stop working, turn
off the heater and inspect for blockages in air
inlet or outlets.Wait at least five minutes for the
protection system to reset before attempting to
restart the heater.
2. Plug the cord into a 230-240V electrical
outlet. Be sure the plug fits tightly as a loose
fit will cause overheating and damage the
plug. To avoid an electrical circuit overload,
it is recommended that no other appliances
are plugged into the same circuit with your
heater when you switch the unit on.
If the heater fails to operate or the safety device
switches off again, return the heater to your
nearest service centre for examination or repair.
3. This heater has three heat control settings
OFF, ”LOW” HEAT AND “HIGH” HEAT,
located at the top of the unit, along with
an adjustable thermostat control. “LOW”
HEAT (750W) is the lowest heat setting and
“HIGH” HEAT (1500W) is the highest.
4. To select these settings DO NOT twist
or rotate the heat control and thermostat
control located on the top of the heater.
To turn the heater on, grip the heat setting
knob and lightly pull all the way up to the
“HIGH” setting. There will be an audible
click as the wedge moves through the
settings. The power indicator light will
illuminate to indicate that power is on.
ꢂ
CARE AND MAINTENANCE
• Always turn off and then unplug the heater
before cleaning
• Use only a clean, dry cloth to clean the external
surfaces of the heater only.
• If the heater has collected dust or dirt inside
the unit or around the elements, have the unit
cleaned by a qualified service agent. Do not
operate the heater in this condition.
• Do not attempt to open the case of the heater
at any time there are no customer serviceable
parts inside.
•When not in use, pack the heater, preferably in
its original box for best protection and store in a
cool, clean and dry location.
•The air filter at the rear of the heater can be
easily cleaned by removing the filter casing panel
and removing the mesh filter.A basic clean in
warm water to remove any build up is adequate
and allow time to completely dry before
replacing the filter and the filter casing panel.
ꢃ
KAMBROOK 12 MONTH REPLACEMENT WARRANTY
If the product includes one or a number of
accessories only the defective accessory
or product will be replaced. In the event of
Kambrook choosing to replace the appliance, the
guarantee will expire at the original date, i.e. 12
months from the original date of purchase.
Kambrook warrants the purchaser against defects
in workmanship and material for a period of 12
months from the date of purchase (3 months
commercial use).
Guarantee and purchase receipt for this product
are to be retained as proof of purchase and
must be presented if making a claim under the
Kambrook guarantee.
In Australia, this KAMBROOK Guarantee is
additional to the conditions and guarantees which
are mandatory as implied by the Trade Practises
Act 1974 and State and Territory legislation.
Kambrook reserves the right to replace or repair
the appliance within the warranty period,
For service, spare parts or product information
in Australia, please call KAMBROOK on the
Customer Service Line; 1300 139 798.
Warranty does not apply to any defect,
deterioration, loss, injury or damage occasioned
by, or as a result of the misuse or abuse, negligent
handling or if the product has not been used in
accordance with the instructions. The guarantee
excludes breakages and consumable items such as
kneading blades.
For service, spare parts or product information
in New Zealand, please call KAMBROOK New
Zealand; 0800 273 845. For spare parts phone
0800 273 845.
This warranty is void if there is evidence of the
product being tampered with by unauthorised
persons.
If claiming this guarantee the product must be
returned freight prepaid.
KAMBROOK 12 MONTH REPLACEMENT WARRANTY
Attach a copy of the purchase receipt here.
YOUR PURCHASE RECORD (Please complete)
DATE OF PURCHASE ___________________
MODEL NUMBER ______________________
SERIAL NUMBER ______________________
PURCHASED FROM ____________________
(Please don’t return purchase record until
you are making a claim)
Kambrook - Australia
461 Plummer Street, Port Melbourne, 3207, Australia
Customer Service Line 1300 139 798
Customer Service Fax 1800 621337
Kambrook - New Zealand
Private Bag 94411, Greenmount, Auckland, New Zealand
Customer Service Line/Spare Parts 09 271 3980
Customer Service Fax 0800 288 513
Due to continual improvement in design or otherwise, the product you purchase may differ slightly from the illustration in this book. Issue 1/07
ꢄ
|