Kambrook 461 Plummer Street, Port Melbourne 3207, Australia
Customer Service Line (free call) 1800 800 634 Customer Service Fax 1800 621 337
Kambrook New Zealand, Private Bag 94411, Greenmount, Auckland, New Zealand
Customer Service Line/Spare Parts 09 271 3980 Customer Service Fax 0800 288 513
Optimum
Radiant Heater
Due to continual improvement in design or otherwise, the product you purchase may differ slightly from the one illustrated in this book. Issue 1/05
KRH600
Issue 1/05
Set the control setting to the OFF
position then Unplug and allow heater to
cool down before cleaning or storing.
NEVER OPERATETHE HEATER
WITHOUTTHE FRONT GRILL
SECURELY IN POSITION.
HOWTO OPERATE
CARE AND MAINTENANCE
• Always turn off the heater at the main
controls and then switch off at power
outlet before unplugging the heater
before cleaning.
Remove your heater from its carton;
unwind the cord to its full length.
TEMPERATURE SETTING
Do not use the heater with a
Remove any element supports Guards (ie
foam or paper packing) by removing the
front guard screws, lift the guard upwards,
support and remove element supports.
Return the guard to the normal position
and replace screws.
programmer, timer or any other device
that switches the heater on automatically,
since a fire risk exists if the heater is
covered or positioned incorrectly.
The heater has 2 heat settings.
• Use only a clean, dry cloth to clean the
external surfaces of the heater only.
• Setting 1 operates the top and middle
elements at 1400 watts
• Do not attempt to remove the front
grill of the heater. The front grill is
designed to hinge upwards only and
never to be removed completely.
• Setting 2 operates all three elements
at 2400 watts
Use this heater only as described in this
instruction manual.Any other use not
recommended by the manufacturer may
cause fire, electric shock or injury and
voids all warranties.
Remove the warning sticker from the
front grill.
The temperature knob (HEAT) acts as an
automatic thermostat and switches the top
element off during setting 1 and both the
top and bottom elements during setting 2:
Read and follow the complete instructions
before plugging the unit into the 230-240
Volt supply.
• Use a vacuum cleaner regularly to
remove dust and fluff from the element
and grill.
Always move the heater with the handle
provided.
• Turn both selector and temperature
knob to high / max settings
Remove the castors from their storage
position on the base and using the same
securing screws fit the castors so that
they are positioned on the outer most
securing holes n the base of the heater.
The heater must never be operated without
the castors secured in the correct position
shown in figure 1.
• If the unit has accumulated dust around
the elements and grill that cannot be
removed with the use of a vacuum
cleaner, have a qualified service agent
clean the unit. DO NOT operate the
heater in this condition.
Regularly inspect the supply cord, plug,
control settings, air inlets and outlets and
main housing for any damage. If found
damaged in any way, immediately cease use
of the heater and return to Kambrook or
an authorized service agent for inspection.
• Once a comfortable room
temperature has been reached, slowly
turn the temperature knob anti-
clockwise until you hear a click and
the top and bottom elements turn off.
• Do not attempt to open the case of the
heater at anytime, there are no
customer serviceable parts inside.
(Note: during Setting 1 only the top element is
controlled with the thermostat)
The installation of a residual current
device (safety switch) is recommended to
provide additional safety protection when
using electrical appliances. It is advisable
that a safety switch with a rated residual
operating current not exceeding 30mA be
installed in the electrical circuit. See your
electrician for professional advice.
Place the heater on a level surface in a
stable position. Make certain the heater
element control switch is in the OFF
position.
• At this setting your heater will
automatically cycle high and low to
maintain the desired room
temperature
• When not in use, pack the heater in its
original box for best protection and
store in a cool, clean and dry location.
Remove the power cord from the storage
compartment on the rear, unwind the
cord fully and plug the power cord in a
240Volt outlet.
Note:There is a tip over switch fitted to this heater.
When the heater tips over, it will turn off
automatically.
WARNING: In order to avoid
overheating do not cover the heater.
Use the rotary switch to select the
desired setting.The red indicator light will
illuminate when the setting is selected.
Fig 1
4
5
Notes
KAMBROOK
12 MONTH WARRANTY
If the product includes one or a number
of accessories only the defective accessory
or product will be replaced.
KAMBROOK warrants the purchaser
against defects in workmanship and
material, for a period of 12 months from
the date of purchase (3 months
commercial use).
In Australia, this KAMBROOK Guarantee
is additional to the conditions and
guarantees which are mandatory as
implied by the Trade Practices Act 1974
and State Territory legislation.
Guarantee and purchase receipt for this
product are to be retained as proof of
purchase and must be presented if making
a claim under the terms of the
For service, spare parts or product
information in Australia, please call
KAMBROOK on the customer Service
Line (free call) 1800 800 634.
KAMBROOK guarantee.
KAMBROOK reserves the right to
replace or repair the appliance within
the warranty period.
For service, spare parts or product
information in New Zealand,
please call KAMBROOK New Zealand,
Greenmount, Auckland Phone 09 271 3980
Fax 0800 288 513. For spare parts phone
09 271 3980.
Warranty does not apply to any defect,
deterioration, loss or injury or damage
occasioned by, or as a result of the misuse
or abuse, negligent handling or if the product
has not been used in accordance with the
instructions.The guarantee excludes
breakages and consumable.
If claiming under this guarantee the product
must be returned to freight prepaid.
This warranty is void if there is evidence
of the product being tampered with by
unauthorised persons.
YOUR PURCHASE RECORD (Please complete)
Attach a copy of purchase
receipt here.
DATE OF PURCHASE___________________________
MODEL NUMBER _____________________________
SERIAL NUMBER (If applicable) ___________________
Please don’t return purchase record
unless you are making a claim
PURCHASED FROM ___________________________
6
7
|