STAINLESS STEEL ELECTRIC KETTLE
KH 1028
STAINLESS STEEL ELECTRIC KETTLE
Operating instructions
KOMPERNASS GMBH · BURGSTRASSE 21 · D-44867 BOCHUM
ID-Nr.: KH1028-01/09-V2
STAINLESS STEEL
ELECTRIC KETTLE
KH 1028
Read these operating instructions carefully before
using the appliance for the first time and preserve
this maual for later reference. Pass this manual on to
whoever might acquire the appliance at a future
date.
• Arrange for defective power plugs and/or cables
to be replaced at once by qualified technicians
or our Customer Service Department.
• Always remove the plug from the power socket
after use. Simply switching the appliance off is
not sufficient, as the appliance is under power
for as long as the plug is connected to the socket.
ƽTo avoid burns and other injuries:
• Always heat water with the lid closed, otherwise
the automatic cut-out may not function. Boiling
water could then spray out over the rim.
• Hot steam clouds may be released. The boiler
also becomes very hot during operation.
Wear oven mitts.
• Ensure that the appliance is standing securely and
vertically before switching it on. Boiling water
can cause an unstable kettle to fall over.
• This appliance is not intended for use by individuals
(including children) with restricted physical, physio-
logical or intellectual abilities or deficiences in
experience and/or knowledge unless they are
supervised by a person responsible for their safety
or receive from this person instruction in how the
appliance is to be used.
Intended use
This appliance is intended for the boiling-up of water
in domestic households. It is not intended for use
with other liquids or for commercial applications.
Technical Data
Voltage:
220 - 240 V / 50 Hz
~
Power consumption: 2500 - 3000 W
Volume:
max. 1.5 l
min. 0.5 l
ꢀ In older electrical installations, the building fuse
(12A) may be triggered due to the high power
consumption.
• Children should be supervised to ensure that
they do not play with the appliance.
Items supplied
Safety information
Water boiler
Base
ƽTo avoid potentially fatal injury
through electric shock:
Operating instructions
• Ensure that the base with the electrical connections
does not come into contact with water! If it has
unintentionally come into contact with water, first
allow it to dry out completely before taking it
into use.
• Only use the water boiler with the supplied base.
• Ensure that the power cable never becomes wet
or damp during operation. Lay the cable so that
it cannot be trapped or otherwise damaged.
- 1 -
Operating Elements
Boiling water
1 Unlocking button
2 On/Off switch
3 Base
4 Scale with integrated control lamps
5 Pourer sieve
ƽDanger
Never place the electrical base 3 in close proximity
to water – a potentially fatal risk!
Notice
Always use fresh tap water. Do not consume any
water that has already stood in the water boiler for
longer than one hour. Do not reboil water that has
cooled down. Always pour old water away.
Microbes could have formed in it!
Commissioning
ƽCaution
Always and only use fresh tap water in the water
boiler! Do NOT consume water that is not specifi-
cally designated as drinking water. If you do, there
will be a risk of damage to your health!
• Lift the kettle off of the base when filling it!
• Open the lid by drawing the unlocking button 1
to the rear and, at the same time, lifting the lid up.
• Hold the kettle upright while filling it. Only in this
way can you correctly read the markings
on the scale 4. Fill the kettle...
– at least to the MIN mark, so that the device does
not overheat,
– no higher than the MAX mark, so that no boiling
water spills out.
• First close the lid and then place the kettle onto
the base 3, ensuring that it is is firmly seated on
the base 3.
• Now insert the plug into the mains power socket.
• Press the ON/OFF switch 2 down until it engages
downwards.
• The control lamps integrated into the scale 4
now indicates that the appliance is heating up.
• The appliance switches itself off, and the control
lamps goes out as soon as the water is on the boil.
The ON/OFF switch 2 is released upwards.
• Before taking the appliance into use, ensure that ...
-
the appliance, the plug and the power cable are
in good working order and...
– all packaging materials have been removed from
the device.
• Fill the appliance with water up to the MAX marking
and let it come to a full boil once – as described
in the next section.
• After it has boiled, pour this water away.
• Rinse the water boiler out with clear water.
• Fill the appliance with water up to the MAX marking
on the scale 4 and then bring it to the boil.
When done, pour this water away also.
The appliance is now ready for use.
- 2 -
ƽWarning
In the event of scale deposits:
• Before descaling, remove the pourer sieve 5
(see chapter "Removing/replacing the pourer
sieve").
• Obtain any decalcifying agent suitable for kitchen
utensils (e.g. decalcifiers for coffee machines)
from a hardware shop. Proceed as detailed in
the instructions provided for the use of the
decalcfying agent.
First remove the plug from the wall power socket before
you lift the kettle from the base 3. This avoids the
risk that any water splashing out could come into
contact with live electrical connections in the base 3,
which could cause a short circuit.
ƽInjury hazard
For safety reasons, the lid should not be opened
while the water is boiling or is very hot.
There is a risk of receiving severe scalds.
Removing/replacing the pouring sieve
• Open the lid.
• Using the finger depression of the pourer-sieve 5,
draw the pourer sieve 5 forwards and, at the
same time, upwards.
Cleaning and Care
• Remove the pourer sieve 5.
ƽDanger
• Clean the pouring sieve 5 with a lightly moistened
dishcloth and under running water.
Do not open any part of the housing.
There are no user-servicable elements inside.
An open housing can create the risk of a lethal
electrical shock.
• After cleaning it, replace the pourer sieve 5.
Ensure that the clasp at the lower end of the pourer
sieve 5 wraps itself around the peg in the water
boiler. Press the pourer sieve 5 downwards until
it is firmly seated.
Never submerse any parts of the appliance in
water or other liquids! This can create the risk
of a life-threatening electrical shock if residual
liquid comes into contact with powered
components.
Notice
Should the scale deposits in the pourer sieve 5 be
firmly established, lay it in a water-vinegar solution
having a ratio of 6:1 for a few hours. The scale
deposits will dissolve themselves. Rinse the pourer
sieve 5 with lots of clear water.
ƽRisk of personal injuries
Before cleaning the appliance, remove the plug
from the mains power socket and allow the appliance
to cool down.
Storage
• Clean the exterior surfaces and the power cord
with a slighly damp cloth. Be sure to dry the
appliance well before taking it back into use.
• For stainless steel surfaces, you can use appropriate
cleaning agents from a specialized dealer.
• Never use detergents, abrasive cleaners or solvents.
These can damage the appliance.
Allow the appliance to cool off completely before
putting it into storage.
• Wind the power cable around the cable retainer on
the underside of the base 3.
• Store the appliance in a dry place.
- 3 -
Disposal
DES Ltd
Units 14-15
Do not dispose of the appliance in your
Bilston Industrial Estate
Oxford Street
Bilston
normal domestic waste. This product is
subject to the provisions of European
Directive 2002/96/EC.
WV14 7EG
Tel.: 0870/787-6177
Fax: 0870/787-6168
e-mail: [email protected]
Dispose of the appliance through an approved disposal
centre or at your community waste facility.
Observe the currently applicable regulations.
In case of doubt, please contact your waste
disposal centre.
Kompernass Service Ireland
Tel: 1850 930 412 (0,082 EUR/Min.)
Standard call rates apply. Mobile operators may vary.
e-mail: [email protected]
Dispose of all packaging materials in an
environmentally friendly manner.
Importer
Warranty and Service
KOMPERNASS GMBH
BURGSTRASSE 21
D-44867 BOCHUM, GERMANY
You receive a 3-year warranty for this appliance as
of the purchase date. The appliance has been manu-
factured with care and meticulously examined before
delivery. Please retain your receipt as proof of purchase.
In the case of a warranty claim, please make contact
by telephone with our service department. Only in
this way can a post-free despatch for your goods
be assured.
The warranty covers only claims for material and
maufacturing defects, not for worn parts or for damage
to fragile components, e.g. buttons or batteries.
This product is for private use only and is not intended
for commercial use.
If this product has been subjected to improper or
inappropriate handling, abuse, or modifications not
carried out by one of our authorised sales and service
outlets, the warranty will be considered void.
Your statutory rights are not restricted in any way
by this warranty.
- 4 -
|