Lanier Worldwide, Inc.
2300 Parklake Dr., N. E.
Atlanta, GA 30345-2979
Emergency Telephone: (800)526-4371
MATERIAL SAFETY DATA SHEET
Section 1: Chemical Product and Company Information
Identity:
Product ID: 117- 0225
MSDS No.
Issued: 9/17/98
Toner for 6113, 6213, 6413, 6514
CP-300
Supersedes:
3/11/96
Synonyms
Toner, Black Toner for Lanier
Date:
9/17/98
& Common M6113, 6213, 6413, 6514
Names:
Prepared by:
Lanier QA/EH&S Department
Uses:
M6113, 6213, 6413, 6514 Copier
European
Contact:
Lanier Worldwide, WSM Europe,
Walter Fricke,
Im Taubental D-41468 Neuss,
Germany +49-2131-387-177
Chemical
Formula:
Mixture, Inert resinated black
powder
Section 2: Composition / Information on Ingredients
PERCENT
85 ~ 90
5 ~ 10
1 ~ 5
CAS No.
25767-47-9
1333-86-4
9003-07-7
102561-46-6
7631-86-9
EXPOSURE LIMITS
not listed
SOURCE
n/a
OSHA PEL ACGIH TLV
Styrene-acrylic resin
Carbon black
Wax
Organic pigment
Silica
3.5mg/m3 3.5mg/m3
not listed
not listed
not listed
n/a
n/a
n/a
1 ~ 5
< 1
*PEL of the product: 15mg/m3 (total dust), 5mg/m3 (respirable dust)
*TLV of the product: 10mg/m3 (total dust), 5mg/m3 (respirable dust)
Section 3: Hazards Identification
HMIS Rating:
FLAMMABILITY = 0
REACTIVITY = 0
HEALTH = 0
SPECIAL = none
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to any non-toxic dust. May
cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort.
Health Hazards of Long Term exposure (Chronic): A manufacturer sponsored chronic inhalation study in rats using a special test toner revealed there
were no lung changes at all in the lowest exposure level (1mg/m3), the most relevant level to potential human exposures. A very slight degree of fibrosis was
noted in 25% of the animals at the middle exposure level (4mg/m3), while a slight degree of fibrosis was observed at the highest exposure level (16mg/m3) in
all animals. These findings are attributed to “Lung Overloading”, a generic response to excessive amount of any dust retained in the lungs for a prolonged
interval. The special test toner was ten times more respirable than commercially available toner to comply with EPA testing protocol and would not function
properly in xerographic equipment.
Section 4: First Aid Measures
Remove to fresh air if effects occur. Consult
local medical personnel
Inhalation:
Eye Contact: In case of contact, immediately flush eyes with
water for 5 minutes.
Ingestion: Dilute stomach contents with water. Call a
physician.
Skin Contact:
Wash with soap and water.
Section 5: Fire Fighting Measures
Suitable extinguishing media: CO2, dry chemical, foam or water.
Extinguishing media which may not be used for safety reasons: none
This material will burn in case of fire. The decomposition products are CO, CO2, and Nox. Avoid inhalation of smoke.
Special protective equipment for fire fighters: none
UEL: n/a
LEL: n/a
1
|