F u j i t s u C o m p u t e r S y s t e m s
Harsh Environment Case
User’s Guide
FPCCC52
I N S T R U C T I O N S
These instructions provide details on using the FPCCC52
Harsh Environment Case (HEC). This HEC is designed for
use with your Stylistic® CT2000 Series CE Tablet. It is made
of durable, non-porous vinyl and has a waterproof zipper.
This case provides maximum protection against water, dust,
and other hazards when transporting, using, or storing your
tablet.
We strongly recommend that you read these instructions
prior to using the HEC with your computer.
Note the following when using the HEC:
•
To avoid overheating, suspend the tablet when charging
the battery while the system is in the case and not in use.
•
To prevent scratches, a screen protector should be
installed on the display window of the HEC. (See
“Installing a Screen Protector” on page 4.) Two screen
protectors are provided with the HEC. Additional screen
protectors can be obtained from your reseller, or from the
Fujitsu Web site at: us.fujitsu.com/computers.
To install your tablet in the HEC, unzip the long zipper that
wraps around three sides of the case and open the case so
that it is flat on a level surface.
Lay the system into the case, with the screen facing the open
window. Zip up the wraparound zipper.
Handstraps
D-rings (four places)
Figure 2. CE Tablet HEC - Back
3
Installing a Screen Protector
1. To ensure good adhesion, clean the exterior surface of
the HEC window with a soft cotton cloth dampened
with isopropyl alcohol before installing the screen pro-
tector. If streaking occurs, gently buff the surface with a
clean, soft cloth.
2. Install the screen protector in accordance with the
instructions contained in the “Care and Maintenance”
chapter of the system User’s Guide.
Additional HEC Information
■
Zipper Pulls: The wraparound zipper has two zipper pulls.
If you want to use a specific port or jack that is located on
the side of the system, position the two zipper pulls so that
the zipper is open only over the port you want to use.
■
Handstraps: On the back of the HEC are two overlapping
elastic handstraps that can be used for comfortably and
securely holding the tablet. Position the system in the
desired orientation, slip your hand under the straps, and
grasp the edge of the HEC.
■
Shoulder Strap: The ends of the elasticized handstraps
have D-rings to which you can attach the shoulder strap.
To secure the shoulder strap, attach the strap clips to two
of the D-rings. The HEC can be carried vertically or hori-
zontally, depending on how you orient the clips.
■
Pen Holder: Once the system is installed in the HEC, the
pen can be stored in the pen holder on the top of the HEC.
4
Caring for the HEC
The HEC is made of rugged materials, and is designed to
withstand daily use. Treat the case as you would a briefcase
or purse.
Occasionally, the HEC may become dirty. The case is made
of non-porous vinyl, so it is easy to clean. Use a clean cloth
and warm soapy water to wash the soiled area.
5
6
7
1250 E. Arques Avenue (M/S 122),
Sunnyvale, California 94085
For more information, call
1-877-372-3473 or visit our Web site at:
us.fujitsu.com/computers
For technical support call:
1-800-8fujitsu (1-800-838-5487)
or e-mail us at: [email protected]
Fujitsu and the Fujitsu logo are registered trademarks of Fujitsu, Ltd., and
Stylistic is a registered trademark of Fujitsu Computer Systems Corporation.
All other trademarks mentioned herein are the property of their respective
owners.
Product description data represents Fujitsu design objectives and is provided
for comparative purposes; actual results may vary based on a variety of
factors. Specifications are subject to change without notice.
© 2004 Fujitsu Computer Systems Corporation. All rights reserved.
FPC58-1117-01
8
|