ADDONICS TECHNOLOGIES
Model: ADIDEU2
Installation Guide
Front View
3. Using the provided Y-power cable, connect the 4-pin
4-Pin Floppy
Power Connector
floppy connector to the power connector of the
converter. This will provide power to the converter.
B-Type USB
Connector
USB Pin
Header
4. At the other end of the Y-power cable is the 4-pin Molex
power connector that you connect to the hard drive.
Back View
IDE Connector
Note:
It is required to set up the IDE hard drive you are
connecting to the converter as a MASTER device.
5. Now connect the B-type USB cable to the USB port on
the converter or use the USB pin header cable.
1. Locate the 40-pin IDE connector of your IDE drive.
4-pin Molex
Power Connector
B-Type USB cable
USB Pin Header
cable
40-pin IDE Connector
Master or Slave
Jumper Settings
2. Connect the converter board to the IDE connector of the
hard drive.
TECHNICAL SUPPORT
Email:
Internet:
Technical Support (8:30 am to 6:00 pm PST)
Phone:
Email:
408 433-3855
|