SAFETY PRECAUTIONS
ASSEMBLY INSTRUCTIONS
(SEE ILLUSTRATION BELOW)
1. Never attach a garden hose to the fill/drain hole
when filling. Dangerous pressure build up could
occur inside roller.
2. Do not fill roller to maximum weight without check-
ing capability of vehicle to safely pull and stop.
3. Never use roller up and down hills; always work across
hills and slopes.
1. Assemble bearings (Ref. 5) into hitch tubes (Ref.
3) so that bearing flange is against outside of hitch
tube. (You may need to place a block of wood
against bearing and carefully tap with a hammer.)
2. Place hitch tubes (Ref. 3) onto both ends of roller
shaft. Assemble a flat washer (Ref. 6) onto each
end of roller shaft and secure with two cotter pins
(Ref. 12).
4. Use caution when turning, slowing or stopping.
5. Always drain roller to keep from freezing.
3. Assemble scraper bar (Ref. 2) to hitch tubes (Ref.
3) using two hex bolts (Ref. 9) and hex lock nuts
(Ref. 10). Do not tighten yet.
4. Assemble ends of hitch tubes (Ref. 3) together
using two hex bolts (Ref. 7) and hex lock nuts (Ref.
10). Do not tighten yet.
SPECIFICATIONS:
Roller Drum:
O.A. Width:
Bearings:
24" Dia. x 48" Wide Welded Steel
Approximately 52"
5. Assemble hitch brackets (Ref. 4) to hitch tubes
(Ref. 3) using two hex bolts (Ref. 8) and hex lock
nuts (Ref.10 ). Do not tighten yet.
1" I.D., Replaceable
6. Tighten bolts and nuts starting with scraper bar
(Ref. 2), then ends of hitch tubes (Ref. 3), and
finally hitch brackets (Ref. 4).
Tow Hitch:
Std. Pin Type - 1/2" Hole
Weight w/ Water: Up to 910 Lbs. Filled with Water
(Note: May be filled with sand)
7. Install hitch pin (Ref. 13) through hitch brackets
(Ref. 4) and secure with hair cotter pin (Ref. 14).
Approx. Sh. Wt.: Approximately 165 Lbs.
6
12
5
1
11
9
3
2
10
5
10
8
6
12
10
9
3
4
10
7
Ref. Part Qty. Description
No. No.
Ref. Part Qty. Description
No. No.
1
2
3
4
5
6
7
62811
24868
48376
24192
43632
43528
46782
1
1
2
2
2
2
2
Roller Assembly
Scraper Bar
Hitch Tube
Hitch Bracket
Bearing, Plastic
Flat Washer, 1"
8
9
43224
43084
2
2
6
1
2
1
1
Hex Bolt, 5/16-18 x 2-1/4"
Hex Bolt, 5/16-18 x 1-3/4"
Hex Lock Nut, 5/16-18
Plug, Lawn Roller
Cotter Pin, 5/32" x 1-1/2"
Hitch Pin
10 43064
11 43709
12 43501
13 47623
Hex Bolt, 5/16-18 x 3" 14 43343
Hair Cotter Pin 1/8"
REPAIR PARTS
303 West Raymond
Sullivan, IL. 61951
217-728-8388
Printed in USA
Form No. 48447 (REV. 5/02)
|