Standard Collection®
COUNTERTOP SINK
FIRECLAY
BARRIER FREE
Standard Collection®
COUNTERTOP SINK
• Classically-styled oval countertop sink
• Made from fireclay china
• Front overflow
• Self-rimming with cutout template supplied
• Design matched to Standard Collection® toilet
and fixtures
❏ 0293.004 Faucet holes on 4" (203mm) centers
❏ 0293.008 Faucet holes on 8" (102mm) centers
(illustrated)
Nominal Dimensions:
22-7/8" x 18-1/2"
(581 x 470mm)
24
(610mm)
FINISHED WALL
OR SPLASHBACK
4
8
OPTIONAL
3-1/4"
(83mm)
Bowl sizes:
(203mm)
(102mm)
3/4
(19mm)
15-3/4" (400mm) wide
11-1/4" (286mm) front to back
6-1/2" (159mm) deep
9-1/4
(235mm)
18-1/2
(470mm)
DRAWING FOR
DIMENSIONAL
PURPOSES ONLY.
IT IS NOT AN EXACT
REPRESENTATION.
8
(203mm)
MIN.
Compliance Specifications -
Meets or Exceeds the
1-3/4" DIA.
32-7/8"
(835mm)
STD. DRAIN
OUTLET
Following Specifications:
• ASME A112.19.9M for
27
(686mm)
MIN.
6
(152mm)
MAX.
Non-Vitreous Ceramic Fixtures
• CAN/CSA B45 Series
22-7/8
(581mm)
SEALING
1-1/8
(29mm)
COMPOUND
BARRIER FREE
CLEARANCE
COUNTERTOP
(BY OTHERS)
9
(229mm)
MIN.
8-1/2
(216mm)
10-3/4"
*
(273mm)
12-7/8"
*
(327mm)
31"
(787mm)
SUPPLIES
AS REQ'D
SUGGESTED
8"
(203mm)
1-1/4" O.D. WASTE
32-7/8"
1-1/4" O.D. TAILPIECE
(835mm)
FINISHED FLOOR
To Be Specified:
❏ Color: ❏ White ❏ Linen
❏ Standard Collection Faucet: 8" spread faucet
No. 2881
❏ Standard Collection Faucet: 4" spread faucet
Nos. 2471, 2171, or 2071
❏ Faucet Finish: Chrome or Satin
❏ Supplies:
NOTES:
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP
*
ARE SUGGESTED.
❏ 1-1/4" Trap:
FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE
TEMPLATE SUPPLIED WITH SINK.
FITTINGS NOT INCLUDED WITH FIXTURES AND MUST BE ORDERED
SEPARATELY.
MEETS THE AMERICAN DISABILITIES ACT GUIDELINES AND
ANSI A117.1 ACCESSIBLE AND USABLE BUILDINGS AND
FACILITIES - CHECK LOCAL CODES.
Install lavatory 864mm (34") from finished floor.
Lavatory installed 51mm (2") minimum from front edge of countertop
provides 686mm (27") knee clearance area.
SEALING COMPOUND SUPPLIED BY OTHERS.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.9M.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
J30
© 2008 AS America Inc.
Revised 2/08
|