Installation
Instructions
4101.100
ARCH
SINGLE CONTROL
KITCHEN PULL-OUT FAUCET
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--
please read these instructions carefully before you begin.
Certified to comply with ANSI A112.18.1M
M968566
RECOMMENDED
TOOLS
Adjustable Wrench
Regular Screwdriver
Phillips Screwdriver
Channel Locks
Turn off water at
main supply.
CAUTION
INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON
1
Installation with ESCUTCHEON: Figure A. Apply a light bead of plumbers putty to underside of ESCUTCHEON (1) if
mounting surface is uneven. Insert SEAL (1) into groove at base of faucet. Insert supply HOSES (2) and SHANK (3)
through ESCUTCHEON (4) and mounting surface.
Assemble RUBBER WASHER (5), BRASS WASHER (6) and threaded LOCKNUT (7) onto SHANK (3) from underside
of sink or mounting surface. Hand tighten LOCKNUT (7) and check that rotation of HANDLE (8) from HOT to COLD
is centered.
Use a screwdriver to tighten SCREWS (9) on LOCKNUT (7). Work your way around LOCKNUT (7), tightening the screws
slightly each time until all are snug to ensure even pressure.
Installation for single hole mounting: Figure B. Insert SEAL (10) into groove at base of ESCUTCHEON (11). Insert
SEAL (1) into groove at base of faucet. Insert supply HOSES (2) and SHANK (3) through ESCUTCHEON (11) and mounting surface.
Assemble RUBBER WASHER (5), BRASS WASHER (6) and threaded LOCKNUT (7) onto SHANK (3) from underside of
sink or mounting surface. Hand tighten LOCKNUT (7) and check that rotation of HANDLE (8) from HOT to COLD
is centered.
Use a screwdriver to tighten SCREWS (9) on LOCKNUT (7). Work your way around LOCKNUT (7), tightening the screws
slightly each time until all are snug to ensure even pressure.
8
8
Figure B
Figure A
1
11
GROOVE IN FAUCET
GROOVE IN FAUCET
1
2
10
3
2
GROOVE IN ESCUTCHEON
3
SINK OR
MOUNTING
SURFACE
4
SINK OR
MOUNTING
SURFACE
5
9
6
7
5
9
6
7
TEST INSTALLED FAUCET
5
Move HANDLE (1) down into "off" position.
Turn on water supplies. Check connections for leaks.
Remove AERATOR (2).
1
With HANDLE (1) down in "off" position, pull HAND SPRAY (3)
from FAUCET (4). SPRAY (HOSE (3) should pull approximately 2 feet
and direct open SPRAY END (3) into sink.
4
Operate handle up and down, in COLD and HOT positions,
to flush water lines thoroughly.
Replace AERATOR (2). Place HAND SPRAY (3) back into FAUCET (4).
Check HAND SPRAY (3) operation:
With faucet on push BUTTON (6) for a broad cleansing
spray. BUTTON (6) will lock into this position.
6
To unlock push opposite end of BUTTON (6). Faucet will
return to standard spray.
3
2
SERVICE
6
3
If faucet drips, operate HANDLE several times from "off" to "on." Do not
apply excessive force.
2
Clogged CARTRIDGE outlets or inlets may cause reduced flow.
To clean, first turn off water supply then:
1
Remove INDEX BUTTON (1), loosen HANDLE SCREW (2) and remove HANDLE (3).
Unthread ESCUTCHEON CAP (4). Unthread three MOUNTING SCREWS (5).
Lift CARTRIDGE (6) off MANIFOLD (7) and remove CARTRIDGE SEALS (8).
4
5
Clean MANIFOLD (7), CARTRIDGE (6) ports and SEALS (8).
Place SEALS (8) into CARTRIDGE PORTS (6a).
Place CARTRIDGE (6) onto MANIFOLD (7) and tighten MOUNTING
SCREWS (5) alternately.
Replace ESCUTCHEON CAP (4), HANDLE (3), tighten HANDLE
SCREW (1) and install INDEX BUTTON (2).
6
8
Test fitting.
6a
7
CARE INSTRUCTIONS:
7
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
M968566
ARCH
SINGLE CONTROL KITCHEN
PULL-OUT FAUCET
MODEL NUMBERS
4101.100
M962717-YYY0A
HANDLE KIT
M962716-0070A
BUTTON AND
SCREW KIT
M907302-YYY0A
ESCUTCHEON CAP
M918506-0070A
CARTRIDGE SCREWS
A951470-0070A
CARTRIDGE
M953173-YYY0A
SPRAY
M911261-0070A
SEAL
M962715-YYY0A
AERATOR
M962721-YYY0A
SINGLE HOLE
ESCUTCHEON KIT
Replace the "YYY" with
appropriate finish code
M962732-YYY0A
ESCUTCHEON KIT
CHROME
STAINLESS STEEL
002
075
060467-0070A
MOUNTING KIT
HOT LINE FOR HELP
For toll-free information and answers to your questions, call:
1-800-442-1902
Weekdays 8:00 a.m. to 6:00 p.m. EST
IN CANADA 1-800-387-0369 (TORONTO 1-905-306-1093)
Weekdays 8:00 a.m. to 7:00 p.m. EST
050448-0070A
WEIGHTS
IN MEXICO 01-800-839-12-00
Product names listed herein are trademarks of American Standard Inc.
©
AS America, Inc. 2008
M968566
|