1
Specifications
Throat Diameter
25 mm (1 in)
8 Ω
Nominal Impedance
Minimum Impedance
Power Handling
7.7 Ω
(2200 –20000 Hz)
Nominal2
40 W
80 W
108.5 dB
1.5 – 18 kHz
2.2 kHz
44 mm (1.7 in)
Aluminium
0.11 mH
Continuous Program3
Sensitivity (1W/1m)4
Frequency Range
Recommended Crossover5
Voice Coil Diameter
Winding Material
Inductance
Diaphragm Material
Flux Density
Mylar
1.7 T
Also available in 16 Ω, data upon request
Mounting and Shipping Information
Two M6 holes 180° on 76 mm (3 in) diameter
Three M6 holes 120° on 57 mm (2.2 in) diameter
Overall Diameter
Depth
Net Weight (1 unit)
Shipping Weight (4 units)
Shipping Box (4 units)
134 mm (5.3 in)
60 mm (2.4 in)
2.8 kg (6.2 lb)
12.1 kg (26.6 lb)
300x160x180 mm
(12x6.3x7.1 in)
1 Driver mounted on B&C ME 45 horn.
2 2 hours test made with continuous pink noise signal (6 dB crest factor) within
the specified range. Power calculated on rated minimum impedance.
3 Power on Continuous Program is defined as 3 dB greater than the Nominal rating.
4 Applied RMS Voltage is set to 2.83V for 8 ohms and 4V for 16 ohms Nominal
Impedance. Average SPL from 1000 to 18000 Hz.
DE 25 | Hf Compression drivers
1" high frequency compression driver. Low mass mylar
diaphragm ensures an extremely flat frequency response and
optimized ceramic magnet assembly, results in high sensitivity
and low distortion up to 18 kHz.
5 12 dB/oct. or higher slope high-pass filter.
|