R
FAN COMPANY
READ AND SAVE THESE INSTRUCTIONS
INSTRUCTIONS FOR MOUNTING INTEGRATED LIGHT FIXTURE
K4, K4B, K4BR, K4S, KG4T
WARNING: To reduce the possibility of electrical shock be sure that the power
is turned off at its source(fuse or circuit breaker). All electrical components
must be installed in accordance with national and local electrical codes.
To reduce the risk of fire and electrical shock, this light fixture should be used
only with UL, ETL & CUL Certified Casablanca ceiling fans.
IMPORTANT: Before discarding any packing material locate the following items:
Fixture
Light Bulb(s)
Dimensions (w/glass)
7” h x 20” w
Weight
2 lbs
K4
4-60W A15 Med. Base
4 - 50w “R” Reflector
4 - 50w “R” Reflector
4 - 60w A15 Med. Base
4 - 60w A15 Med. Base
K4B
K4BR
K4S
KG4T
6 1/4” h x 10 to 19” w
7” h x 11 to 19” w
6” h x 20 1/2” w
3 lbs
2 lbs
2 lbs
5 1/2” h x 17 1/2”w
4 lbs
INSTALLATION
For fan models ending in A, D, M, R,
T, V, W: (For K4BR — See Step 10
First!!)
SWITCH
HOUSING
1. Remove the cover from fan by removing two brass
8-32 screws and save these screws for attaching light
fixture. Remove plastic wire nuts from switch housing
wires and strip 1/2" insulation from both wires (black or
blue, and white). This cover will not be reused. See
FIG. 1
COVER
8-32 SCREW
NOTE: If installing this light fixture on a 3 Speed
pull-chain model fan, a separate pull-chain switch
(included with the fan) must be installed. Refer to
the following installation instructions, otherwise
skip to step 4.
FIG. 1
WHITE WIRE
KNURL NUT
2. Remove the plastic plug from the fan switch hous-
ing. Install the light on-off switch by inserting the chain
through hole, from the inside. Pass the switch threads
into the hole and screw the knurl nut onto the switch.
Hand tighten firmly. See FIG. 2
PLASTIC PLUG
BLUE WIRE
WIRE NUT
3. Attach the blue wire from the fan to one of the blue
wires on the switch by twisting the bare ends of the
wires together. Secure the splice by threading on one
of the wire nuts provided. Test the secureness of the
splice by pulling on the wire nut.
PULL-CHAIN
SWITCH
FIG. 2
89443470
Jul. 03
|