CLEANING INSTRUCTIONS
1. Be sure the plug has been removed from outlet.
2. Remove can opener lever by lifting and pulling
toward you. Wash by hand with hot, sudsy water.
Dry thoroughly.
3. Wipe body of can opener with damp cloth.
(Caution: Do not immerse in water.)
4. Replace can opener lever by holding in the upright
position and snapping back into place.
SUGGESTIONS
This can opener will open virtually all standard size
cans. It should not be used on cans that have
alternate methods of opening (including but not
limited to pull-tabs, rolling key and peel-off foil). It
also should not be used with rimless cans or cans
with angled corners.
Cans with aluminum lids will not adhere to magnet.
If there is a dent in the rim of the can, open other side
or place the Power CutTM blade beyond the dent. If the
can opener stalls, use a light touch to turn the can to
aid the cutting process.
Die Cast Can Opener
Instruction Booklet
DCO-24
IMPORTANT
SAFEGUARDS
When using electrical appliances, basic safety precau-
tions should always be followed including the following:
1. READ ALL INSTRUCTIONS.
2. To protect against risk of electrical shock, do not
immerse cord, plug or can opener in water or
other liquid.
3. Close supervision is necessary when any
appliance is used by or near children.
4. Unplug from outlet when not in use, before putting
on or taking off parts, and before cleaning.
5. Avoid contacting moving parts.
6. Do not operate any appliance with a damaged cord
or plug, or after the appliance malfunctions, or is
dropped or damaged in any manner. Return
appliance to the nearest authorized Cuisinart
service facility for examination, repair or
mechanical/electrical adjustment.
7. The use of attachments not recommended or sold
by Cuisinart may cause fire, electrical shock, or risk
of injury.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter,
or touch hot surfaces.
10. Do not open pressured (aerosol type) cans.
11. Do not open cans of flammable liquids such as
lighter fluid.
12. Do not use can opener for other than intended use.
13. Do not leave unattended while in use.
14. This appliance is intended for household use only
and not for commercial or industrial use.
15. Caution: Do not immerse in water.
FOR HOUSEHOLD ONLY
SAVE THESE
INSTRUCTIONS
NOTICE
This appliance has a polarized plug (one blade is wider
than the other). As a safety feature, this plug will fit in a
polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Do not attempt to defeat
this safety feature.
OPERATING INSTRUCTIONS
1. Plug cord into outlet.
2. Raise can opener lever.
3. Position the can under the guiding posts and lower
the lever, making sure the Power CutTM blade is
positioned inside the rim of the can.
4. Once the Power CutTM blade pierces the can,
cutting begins. There is no need to hold the lever
down during cutting.
5. Cutting action will automatically stop, once can is
completely open.
6. Can will remain in position until lever is lifted.
7. To remove can, hold can firmly with one hand while
lifting lever with the other.
8. Carefully remove lid from magnet.
2
1
4
3
2
3
1
3
4
6
5
TM
1. Power Cut Blade Assembly
2. Can Opener Lever
3. Guiding Posts
4. Can Stop
5. Base
6. Cord Storage (not shown)
Version no.: DCO24 IB-3853BFT
SIZE: 89mm(W) x 172mm(H)
Total Pages : 6pcs
Material: 120gsm Gloss Artpaper
Cover:
Inside:
Coating:
Color:
Cover: 4C + 1C
Inside: 1C + 1C
Date: 02/18/05
P. O.: 0502000 (02/00/2005_OP)
Tel: 2357 0071
Fax: 2357 0318
|