INSTALLING FILTER ASSEMBLY- 600 Models
(except D and DX)
INSTALLING FILTER ASSEMBLY- 600 D, DX
The AllerAir 600 models ship with their large carbon filters in a separate box.
The AllerAir 600 models ship with their large carbon filters in a separate box.
This is done to safeguard your unit during shipping. To insert the filter, refer to the diagram below.
This is done to safeguard your unit during shipping. To insert the filter, refer to the diagram below.
Step 1
Turn Power Off and
unplug receptacle.
Step 3
Gently grasp wheels.
Step 2
Step 1
Turn Power Off and
unplug receptacle.
Step 2
With a #2 Philips screw driver,
remove the four screws from the
bottom of the unit.
With a #2 Philips screw driver,
remove the four screws from the
bottom of the unit.
Remove base by gently pulling on
the wheels.
Step 3
Gently grasp wheels.
Lay unit upside down.
Lay unit upside down.
Step 5
Step 6
Step 4
Step 5
First remove the HEPA filter by
placing thumbs on the inner side of
the filter.
Than remove the Carbon filter by
placing thumbs on the inner side of
the filter.
Step 6
Replace the gasket that had been
removed in STEP 4.
Remove only one of the white, felt,
donut-shaped gaskets from the
inside of the purifier body.
Insert the carbon filter (either a
Model 600 D Carbon or a Model 600
DX Carbon) into the unit.
Step 4
Remove base by gently pulling on
the wheels.
Then pull up gently until totally out.
Then pull up gently until totally out.
Step 9
With a screw driver, place 4
screws back into their positions.
Step 7
Step 7
Step 8
Step 9
Turn the unit back onto its wheels.
It is now ready for immediate use.
Place lid back to its proper position
by aligning the arrow with the rear
seam.
Replace filters with new ones then
reassemble by inserting the Carbon
filter first then the HEPA filter.
Place lid back to its proper position
by aligning the arrow with the rear
seam.
Step 8
Replace the four screws
Gently return the unit into
upright position.
AllerAir Industries Inc.
AllerAir Industries Inc.
|