INSTALL INSTRUCTIONS C-TM-EXPD
HEAVY DUTY TRAK MOUNT
2003-2006 FORD EXPEDITION
TOOLS REQUIRED:
Metric socket set
Ratcheting wrench
Standard socket set
HARDWARE:
QTY DESCRIPTION
PART #
16
8
8
8
1
¼-20 x 3/4” Hex Head Bolt
¼” Flat Washer
¼” Lock washer
¼” Serrated nut
Front transmission hump bracket
Rear transmission hump bracket
32” Trak Mount
GSM33001
GSM31005
GSM31026
GSM30023
C-B35
1
1
C-B36
C-TM-32E
Always!
ꢀ Read all instructions before installing any Havis-Shields Equipment Corp products.
ꢀ Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
ꢀ Use hardware provided with install kit
ꢀ For product support, visit the Install Instructions Section of our website at
Front
INSTALLATION:
1. Remove O.E.M. console if applicable.
2. Remove inner front and rear seat-
mounting bolts near transmission hump.
Loosen outer bolts only.
3. Place front and rear hump brackets legs
in place under seat brackets. Do not bolt
down.
4. Position cross piece and trak mount on
top of legs.
5. Determine best position for application.
6. Attach trak to cross pieces using ¼” x
¾” hex bolts and serrated nuts.
7. Attach trak and cross piece assembly to
mounting legs using ¼” x ¾” bolts and
washers.
Rear
8. Tighten all seat bolts
9. Attach console and/or accessories.
C-TM-EXPD-INST-2-07
|